Page 1 of 1

Tragic terrain problem in NZWN P3DV5HF2

Posted: Sat Jun 27, 2020 9:14 am
by csh007
I installed orbx Globle and orbx NZ SI&NI.
Conflict detection has been carried out in accordance with your approach and all green active.
Follow your settings for P3D.
Because it is in addon mode, it is impossible to manually adjust the position of the landscape layer.
Now the entire NZWN and the surrounding terrain have been severely split, and ridges have appeared on the runway.
My newly installed P3D V5 HF2.
Your products are not individually adapted for P3DV5, but the transplantation of V4 is inevitably problematic, because the terrain and plane of the entire P3DV5 have been greatly adjusted.

Image

Image

Image

Image

Image

Re: Tragic terrain problem in NZWN P3DV5HF2  [SOLVED]

Posted: Sat Jun 27, 2020 9:57 am
by SammyH
You are looking at the wrong thing.

You need to look at the Scenery Library order, that is what determines the priority in the sim, not the Add-on tab.

So go back into your sim and make sure under the "Scenery Library" tab that NZWN is above all your ORBX entires. If it is not then you will need to go into ORBX control panel and set the priority for your ORBX scenery below all others. There are instructions on the ORBX forum how to do that.

Re: Tragic terrain problem in NZWN P3DV5HF2

Posted: Sat Jun 27, 2020 10:22 am
by csh007
This problem was solved satisfactorily, and I will continue to wish to buy FB's NZAA and Toulouse products. Thank you very much

Image

Image

Image

Re: Tragic terrain problem in NZWN P3DV5HF2

Posted: Sat Jun 27, 2020 9:11 pm
by SammyH
No problem, glad it all is working now.

Re: Tragic terrain problem in NZWN P3DV5HF2

Posted: Thu Jul 09, 2020 10:46 am
by micstatic
this actually helped me fix a long time battle I've had with this too. Very simple solution. Scenery looks beautiful again and well blended. thanks

Re: Tragic terrain problem in NZWN P3DV5HF2

Posted: Thu Jul 09, 2020 11:08 am
by SammyH
Glad to hear.